5. Press the START/STOP button once.
6. Exit. Unless you are making changes to other parameters.
Troubleshooting
A remote 3-A timer with a 3-A T-MAX timer on the bed.
Remote 3-A counts down, but the bed timer reads * 0*
1. Get into parameters on the remote timer.
2. Set remote timer’s bed address to * .0*
3. Exit parameters.
Remote timer displays *39*.
1. Check bed address. Make sure bed address is set to * .1* (solid decimal, solid one).
2. Check timer cord (phone cord) between bed and remote timers. If another timer cord is
available, try replacing the existing timer cord.
Note: Do not replace timer cords with regular phone cords. They will not work, and may damage
the timers.
Bed timer (and remote timer if applicable) counts down, but the bed is not coming on
1. Check wire connections
a. On the bed timer board (connector marked CONTACT).
b. At the bed.
Display is dead
1. Is the timer plugged in all the way?
2. Does the timer have it’s own power supply?
3. Check power connections on timer board. (connector marked PWR IN 9-12V)
4. Check the wall outlet with another timer, or radio if another timer is not available, to make
sure the wall outlet works.
T-MAX PLUS/PRO Guide
Initial Setup
Before you plug in the T-MAX Manager Plus/PRO, make sure each bed has a different bed
address. If there are two or more beds with the same address, the T-Max Manager Plus/Pro may
not pick that address up and it may get confused and not pick up any other beds.
1. Apply power to the T-MAX Manager Plus/PRO. The T-MAX Manager Plus/PRO will scan the
network to find all the 3-As.
2. Press the Call/Menu button. The display should show the following Security #. Enter
your level 3 code. A sheet was provided with the T-MAX Manager Plus/PRO with the factory
default settings for each security level.
3. The display should read: GET PARAMS? Press Next.
4. The display should read: SEND PARAMS? Press Next.
5. The display should read: MGR PARAMS? Press Enter.
6. The display should read: MGR DELAY TIME. Enter the amount of delay time, in minutes,
you give your customers to get ready, then press Enter. (0~10 minutes available. 0=
automatic start up.)
7. The display should read: MGR START MODE.
a. Enter a 1 if you want the bed to automatically start up when the session delay ends (if any).
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais